Yamaha BANSHEE 350 YFZ350A Owner's Manual page 92

1
2
3
4
5
6
1. Coolant reservoir cover
2. Coolant reservoir cap
7
5. Remove the coolant reservoir cap, add cool-
8
ant or distilled water to the maximum level
mark, and then install the reservoir cap.
9
NOTICE: If coolant is not available, use
distilled water or soft tap water instead. Do
10
not use hard water or salt water since they
are harmful to the engine. If water has
11
been used instead of coolant, replace it
with coolant as soon as possible, other-
wise the cooling system will not be pro-
tected against frost and corrosion. If water
has been added to the coolant, have a
1
2
Yamaha dealer check the antifreeze con-
tent of the coolant as soon as possible,
otherwise the effectiveness of the coolant
will be reduced.
Coolant reservoir capacity (up to the maximum
level mark):
0.28 L (0.30 US qt, 0.25 Imp.qt)
6. Close the coolant reservoir cover.
7. Install the seat.
TIP
If the engine overheats, see page 8-56 for further
instructions.
EBU23525
To change the coolant
EWB01890
WARNING
Wait for the engine and radiator to cool before
removing the radiator cap. You could be
burned by hot fluid and steam blown out under
pressure. Always place a thick rag over the cap
when opening. Allow any remaining pressure
to escape before completely removing the cap.
1. Place the ATV on a level surface.
8-14
[ECB01011]