Lubricating The Drive Chain; Checking And Lubricating The Cables - Yamaha BANSHEE 350 YFZ350A Owner's Manual

Tightening torques:
Locknut:
16 Nm (1.6 m·kgf, 12 ft·lbf)
Axle holding nut (upper):
120 Nm (12 m·kgf, 87 ft·lbf)
Axle holding nut (lower):
60 Nm (6.0 m·kgf, 43 ft·lbf)
EBU24882

Lubricating the drive chain

The drive chain must be cleaned and lubricated at
the intervals specified in the periodic maintenance
and lubrication chart, otherwise it will quickly wear
out, especially when riding in dusty or wet areas.
Service the drive chain as follows.
ECB00561
NOTICE
The drive chain must be lubricated after wash-
ing the ATV or riding in the rain or wet areas.
1. Clean the drive chain with kerosene and a
small soft brush. NOTICE: To prevent dam-
aging the O-rings, do not clean the drive
chain with steam cleaners, high-pressure
washers or inappropriate solvents.
1. O-ring
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive chain with a
special O-ring chain lubricant. NOTICE: Do
not use engine oil or any other lubricants
for the drive chain, as they may contain
substances that could damage the O-
rings.
EBU24901

Checking and lubricating the cables

The operation and the condition of all control ca-
[ECB00571]
bles should be checked before each ride, and the
cables and cable ends should be lubricated if nec-
8-45
1
[ECB00581]
1
1
2
3
4
5
6
7
8
9
10
11