Installing A Wheel; Troubleshooting - Yamaha BANSHEE 350 YFZ350A Owner's Manual

Rear
1
1
2
3
4
5
6
1. Wheel nut
7
3. Elevate the ATV and place a suitable stand
8
under the frame.
4. Remove the nuts from the wheel.
9
5. Remove the wheel.
10
EBU25661

Installing a wheel

11
1. Place the ATV on a level surface.
2. Install the wheel and the nuts.
3. Lower the ATV to the ground.
4. Tighten the wheel nuts to the specified
torques.
1
8-54
Tightening torques:
Front wheel nut:
45 Nm (4.5 m·kgf, 33 ft·lbf)
Rear wheel nut:
45 Nm (4.5 m·kgf, 33 ft·lbf)
EBU25740

Troubleshooting

Although Yamaha ATVs receive a thorough in-
spection before shipment from the factory, trouble
may occur during operation. Any problem in the fu-
el, compression, or ignition systems, for example,
can cause poor starting and loss of power.
The following troubleshooting charts represent
quick and easy procedures for checking these vital
systems yourself. However, should your ATV re-
quire any repair, take it to a Yamaha dealer, whose
skilled technicians have the necessary tools, expe-
rience, and know-how to service the ATV properly.
Use only genuine Yamaha replacement parts. Im-
itation parts may look like Yamaha parts, but they
are often inferior, have a shorter service life and
can lead to expensive repair bills.
EWB02280
WARNING
Do not smoke when checking the fuel system.