Yamaha BANSHEE 350 YFZ350A Owner's Manual page 109

4
1. Mixing chamber cap securing plate
2. Projection
3. Slot
4. Screw
7. Tighten the mixing chamber cap securing
plate screw to the specified torque.
Tightening torque:
Mixing chamber cap securing plate screw:
3.5 Nm (0.35 m·kgf, 2.5 ft·lbf)
8. Tighten the carburetor joint screws.
2
1
3
Adjusting the throttle cables
1. Move the throttle lever a few times.
2. Push the throttle lever forward until it stops
and hold it in this position.
3. Check through each carburetor window to see
if the punch mark on the throttle valve is at the
specified position.
1
2
1. Punch mark
2. Specified position: 0–1mm
4. If not, loosen the locknut and turn the adjust-
ing nut until the specified position is obtained.
8-31
1
2
3
4
5
6
7
8
9
10
11