Acli Access Procedures - Avaya 4550T-PWR+ Fundamentals

Command mode and
sample prompt
Privileged EXEC 4548GT-
PWR#
Global Configuration
4548GT-PWR(config)#
Interface Configuration
4548GT-PWR(config-if)#
Router Configuration
ERS4000(config-router)#

ACLI access procedures

About this task
Perform the procedures in this section to access ACLI.
Prerequisites
• Connect to the switch with a console cable, connected directly to the console port, or use
Telnet.
• To connect to the switch remotely, through Telnet, ensure that you enable remote access
and that the switch IP address is valid.
Fundamentals
Entrance commands
enable
From Privileged EXEC
mode, enter
configure
From Global Configuration
mode: To configure a port
enter
interface
fastethernet <port
number>
To configure a VLAN enter:
interface vlan
<vlan number>
From Global Configuration
mode, to configure OSPF,
enter:
router ospf
To configure RIP, enter:
router rip
To configure VRRP, enter:
router vrrp
Exit commands
exit
or
logout
To return to Privileged EXEC
mode, enter
end
or
exit
To exit ACLI completely,
enter
logout
To return to Global
Configuration mode, enter:
exit
To return to Privileged EXEC
mode, enter:
end
To exit ACLI completely,
enter:
logout
To return to Global
Configuration mode, enter:
exit
To return to Privileged EXEC
mode, enter:
end
To exit ACLI completely,
enter:
logout
December 2011
ACLI concepts
21