Configure Access Control; Check A Configuration - Avaya 4550T-PWR+ Fundamentals

ssl
ssl reset
show ssl

Configure access control

Configure access control by performing the commands in the following table.
ipmgr source-ip 1 <trusted
net> mask <mask>
ipmgr source-ip 2 <trusted
net2> mask <mask>
ipmgr source-ip
ipmgr source-ip
show ipmgr

Check a configuration

To display the switch configuration enter the command: show running-config.
Fundamentals
Command
Command
<1-50>
<51-100> <WORD> Select IPv6 address or prefix where WORD
Purpose
generic certificate with a new certificated
generated by the ssl certificate
command.
Enables SSL server.
Resets the SSL server.
When SSL is enabled: existing SSL
connections are closed, the SSL server is
restarted and initialized with the certificate
that is stored in the NVRAM. When SSL is
not enabled: existing non secure
connections are closed, the server is
restarted, and non secure operation
resumes.
Display SSL settings.
Purpose
Enable management from the trusted net.
Enable management from trusted net 2.
Select address or mask pair.
is the IPv6 address or prefix from which
connections are allowed.
Display access control configuration.
Configure access control
December 2011 83