Flight Environment, Binding; Arm/Disarm The Motors - Hubsan X4 DESIRE H502S Instruction Manual

5. START TO FLY
5.1 FLIGHT ENVIRONMENT
(1) The flying area should be open and without tall buildings or other obstacles; the steel
structure within buildings interferes with the compass and the GPS signal.
(2) DO NOT fly in bad weather such as strong wind, heavy snow, rain or fog.
(3) Keep away from barriers, people, power cables, trees, and other obstructions.
(4) Do NOT fly near radio towers or airports.
(5) The X4 control system will not work properly at the South or North Pole.
(6) DO NOT fly in restricted areas and obey your country's laws and regulations.
High Tension Line
5.2 BINDING
The binding is completed in factory.
For re-binding, press Photo button and power on the transmitter simultaneously until "Bind to
Plane" displayed, then power on the drone, and place it very close to the transmitter, the binding
will be completed after one " beep" heard.
Should the binding failed, please power off the drone and repeat above steps.
5.3 ARM/ DISARM THE MOTORS
Arm the motors
Method : Pull the left stick to the left lowest corner and the right
stick to the right lowest corner as the picture shows. Release
both sticks after the motors are armed.
If the motors can not be armed after binding, please make sure:
1. Compass calibration is completed
2. The value of Fly When No GPS is "YES"
3. GPS switch and RTH switch is OFF.
Disarm the motors
Method : Pull the left stick to the left lowest corner and the right
stick to the right lowest corner again, and release both sticks after the motors are disarmed.
Do not stop the motors during the flight to avoid crashing.
Push the sticks lightly. Release the sticks after the motors are armed or disarmed.
Airport Interference Rain
06
©
2016 Hubsan