Gps Positioning/Home Point Setting; Return To Home - Hubsan X4 DESIRE H502S Instruction Manual

6. ADVANCED PERFORMANCE SETUP
6.1 GPS POSITIONING/ HOME POINT SETTING
1.) GPS Positioning works ONLY when the GPS signal has no less than 6 satellites.
Push up the GPS switch to activate the GPS positioning.
Pull down the GPS switch to exit the GPS positioning (only altitude hold will be active).
2.) Home Point is recorded when armed the motors with no less than 6 GPS satellites.
3.) You should be in an open place to search for the GPS satellites, it'll take 3 mins to finish the
searching, and the GPS signal strength depends on the flying environment.
6.2 RTH MODE (RETURN TO HOME)
ENTER INTO RTH MODE
Push the GPS Switch and the RTH Switch up, and the quad copter will enter into RTH mode.
The flight control system will control the quad copter to fly back to the home point and land
automatically.
!
The RTH MODE only works when the GPS mode is activated with no less than 6 satellites.
The Home Point is recorded when armed the motors with no less than 6 GPS satellites.
09
©
2016 Hubsan
00:23:59
X4
7.3V
0.3m/s
R 0
1.5m
P 0
0m
H 247
GPS 6 N22.7914931 E:114.0479740
X4
GPS 6 N:22.7914650 E:114.0479983
Altitude
00:23:59
X4
7.3V
R 0
P 0
H 247
X4 GPS 6 N22.7914931 E:114.0479740
GPS 6 N:22.7914650 E:114.0479983
Altitude
0.3m/s
1.5m
0m