Menu 7: Adjustable Switching Hysteresis; Operation Ecohome Or Ecooffice Mode; Getting Started - Pentair NRG-Temp Operation Manual

5.3.7 Menu 7: adjustable switching hysteresis

The switching hysteresis can be adjusted to extended
On/Off cycles: Adjustable: from 0.2 - 2.0°C
Factory setting. 0.5°C
6. OPEraTiOn ECOHOME Or
ECOOFFiCE MODE

6.1 Getting started

note:
The function being set is indicated by a square
symbol around the function symbol. Example: If the
square is shown around the clock symbol, the time and
date function may be amended.
The sensor mode is detected and initialised
automatically.
If the floor sensor cable is connected, it operates
in floor sensor mode. To change the sensing mode
to room sensing with floor sensor limiter, see
paragraph 4.2.4. Menu 1.
If the floor sensor is not connected, the NRG-Temp
operates in room sensing mode.
To program the thermostat follow the steps A, B, C
and D below.
The program EcoHome and EcoOffice can be selected as
described on page 12 program selection.
a. set the time and day <
"time flashes"
"hour flashes" Set hour with <
"day flashes"
Thermostat starts operating in pre-set program
EcoHome or EcoOffice.
learning function: see page 16.
Set minutes with <
Press <
Press <
Set day with <
Press <
Day 1 is Monday/ Day 7 is Sunday.
>
> to confirm .
> button.
> to confirm.
> button.
> to confirm.
> button.
25