Ir Infrared Remote Control; Ir Remote Operation - Chauvet WELL FIT User Manual

IR Infrared
Remote
Control
IR Remote
Operation
Note: The IR remote will not respond to any inputs when the Black Out mode is activated. If the
remote does not respond when a button is pressed, try pressing <BLACK OUT>. You may have
inadvertently activated the Black Out mode.
WELL Fit User Manual Rev. 1
Infrared (IR) mode allows the product to be controlled with an infrared remote
controller. The IR remote can remotely set the product to various modes; adjust
the color, speed and sensitivity; and set the strobe.
The WELL Fit is compatible with the included IR remote from Chauvet. To
enable use with the IR remote, follow the instructions below:
1. Go to IR Setting in the main level.
2. Select On to activate the IR Receiver.
It may be necessary to turn the product off and on again when switching
from W-DMX to IRC and vise-versa.
Be sure the IR remote is pointing directly at the product and there is nothing in
between the remote and the product.
Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press <AUTO> on the IR remote.
2. Press <+> or <–> to choose between the four different auto programs.
To adjust the speed of the automatic program:
1. Press <SPEED> on the IR remote.
2. Press <+> or <–> to either increase or decrease the speed of the program.
Manual Color Control
To choose a specific color with the IR remote:
3. Press <MANUAL> on the IR remote.
4. Press any number between <0> and <9> to choose your color.
To manually control the RGBA percentage:
1. Press <MANUAL> on the IR remote.
2. Press <R>, <G>, <B>, or <A> (red, green, blue, or amber) to choose your
color.
3. Press <+> or <–> to increase or decrease the percentage of each color.
Miscellaneous Operation
To adjust the strobe rate of the program:
1. Press <STROBE> on the IR remote.
2. Press <+> or <–> to increase or decrease the strobe rate.
3. Press <STROBE> again to turn off the strobe.
To choose a fade auto program:
·
Press <FADE> repeatedly on the IR remote to choose between the two
auto program fade options
To black out the lights:
·
Press <BLACK OUT> on the IR remote. This will turn off all the lights until
the button is pressed again.
To adjust the output level:
1. Press <%> on the IR remote.
2. Press <+> or <–> to increase or decrease the output level.
Setup
-9-