D-Fi Usb Connectivity; Irc-6 (Infrared Remote Control); Dmx Linking - Chauvet Festoon Quick Reference Manual

EN
The Festoon String is for indoor or temporary outdoor use (IP43). Do not expose to harsh or
excessively corrosive environmental conditions (whether indoors or outdoors), including, but
not limited to, extreme temperatures, humidity, atmospheric conditions (including salinity or
pressure), radiation (UV, infrared or nuclear), shock and conditions which exceed the
product's Ingress Protection (IP) rating.
The Festoon Strings may be exposed to rain and moisture, as long as the bulbs hang at a 90°
angle to the ground. The Festoon controller is not intended for outdoor use.
Festoon Bulbs MUST hang at a
90 degree perpendicular angle
to maintain an IP43 rating.

D-FI USB Connectivity

The Festoon is able to become a D-Fi wireless receiver/transmitter with the use of the D-Fi USB from CHAUVET DJ.
Simply set the DIP switch D-Fi receiving/transmitting channel, plug it into the USB port then set the product's DMX
Personality and DMX Address. Further instructions for connecting and configuring this product for D-Fi USB operation
are in the Festoon User Manual or D-Fi USB Instruction Sheet.
WARNING! DO NOT plug anything other than a D-Fi USB into the USB port. Doing so may
cause damage to the product.

IRC-6 (Infrared Remote Control)

The Festoon is fully compatible with the Infrared Remote Control (IRC-6) from CHAUVET DJ. For more information on
the IRC-6 or to download instructions, go to www.chauvetdj.com.

DMX Linking

The Festoon can work with a DMX controller. Instructions for connecting and configuring this product for DMX operation
are in the User Manual. If you are not familiar with DMX or DIP-switch configuration, download the DMX Primer from
www.chauvetdj.com.
Starting Address
To ensure full access to the channels available in DMX mode, the highest recommended DMX address is
• 3-CH Mode - 510
• 9-CH Mode - 504
• 60CH / 120CH / 180CH Mode - 453 / 393 / 333
Master/Slave Connection
The Festoon uses the DMX data connection for its Master/Slave mode. Instructions for connecting and configuring this
product for Master/Slave operation are in the User Manual.
Festoon QRG Rev. 4
QUICK REFERENCE GUIDE
6