Report-Aggregation (Mld Snooping View); Reset Mld-Snooping Group - HP A5120 EI Series Command Reference Manual

report-aggregation (MLD snooping view)

Syntax
report-aggregation
undo report-aggregation
View
MLD snooping view
Default level
2: System level
Parameters
None
Description
Use the report-aggregation command to enable MLD report suppression.
Use the undo report-aggregation command to disable MLD report suppression.
By default, MLD report suppression is enabled.
This command works only on MLD snooping–enabled VLANs.
Examples
# Disable MLD report suppression.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] undo report-aggregation

reset mld-snooping group

Syntax
reset mld-snooping group { ipv6-group-address | all } [ vlan vlan-id ]
View
User view
Default level
2: System level
Parameters
ipv6-group-address: Specifies an IPv6 multicast group. The effective range of ipv6-group-address is
FFxy::/16—excluding FFx0::/16, FFx1::/16, FFx2::/16 and FF0y::, where x and y represent any
hexadecimal number between 0 and F, inclusive.
all: Specifies all IPv6 multicast groups.
vlan vlan-id: Specifies a VLAN. The effective range of vlan-id is 1 to 4094.
Description
Use the reset mld-snooping group command to remove the dynamic group entries of a specified MLD
snooping group or all MLD snooping groups.
66