Subvlan (Multicast Vlan View) - HP A5120 EI Series Command Reference Manual

Use the undo port multicast-vlan command to restore the default.
By default, a port does not belong to any multicast VLAN.
A port can belong to only one multicast VLAN.
Examples
# Assign GigabitEthernet 1/0/1 to multicast VLAN 100.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port multicast-vlan 100

subvlan (multicast VLAN view)

Syntax
subvlan vlan-list
undo subvlan { all | vlan-list }
View
Multicast VLAN view
Default level
2: System level
Parameters
vlan-list: Specifies a VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to end-vlan-
id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a VLAN ID is 1
to 4094.
all: Specifies all the sub-VLANs of the current multicast VLAN.
Description
Use the subvlan command to configure sub-VLANs for the current multicast VLAN.
Use the undo subvlan command to remove the specified sub-VLANs or all sub-VLANs from the current
multicast VLAN.
A multicast VLAN has no sub-VLANs by default.
The VLANs to be configured as sub-VLANs of the multicast VLAN must have existed and must not be
multicast VLANs or sub-VLANs of another multicast VLAN.
Examples
# Configure VLAN 10 through VLAN 15 as sub-VLANs of multicast VLAN 100.
<Sysname> system-view
[Sysname] multicast-vlan 100
[Sysname-mvlan-100] subvlan 10 to 15
37