Igmp-Snooping Proxying Enable - HP A5120 EI Series Command Reference Manual

Parameters
vlan vlan-list: Specifies one or multiple VLANs. You can provide up to 10 VLAN lists. For each list, you
can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to end-
vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a VLAN ID
is 1 to 4094.
Description
Use the igmp-snooping overflow-replace command to enable the multicast group replacement function on
the current port.
Use the undo igmp-snooping overflow-replace command to disable the multicast group replacement
function.
By default, the multicast group replacement function is disabled.
This command works only on IGMP snooping–enabled VLANs.
If you do not specify any VLAN when using this command in Layer 2 Ethernet interface view or Layer 2
aggregate interface view, the command takes effect in all VLANs that the interface belongs to. If you
specify a VLAN or multiple VLANs, the command takes effect in the specified VLANs that the interface
belongs to.
If you do not specify any VLAN when using this command in port group view, the command takes effect
on all the ports in this group. If you specify a VLAN or multiple VLANs, the command takes effect only on
those ports in this group that belong to the specified VLANs.
Related commands: overflow-replace.
Examples
# Enable the multicast group replacement function on GigabitEthernet 1/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] igmp-snooping overflow-replace vlan 2

igmp-snooping proxying enable

Syntax
igmp-snooping proxying enable
undo igmp-snooping proxying enable
View
VLAN view
Default level
2: System level
Parameters
None
Description
Use the igmp-snooping proxying enable command to enable the IGMP snooping proxying function in a
VLAN.
Use the undo igmp-snooping proxying enable command to disable the IGMP snooping proxying function
in a VLAN.
19