Igmp-Snooping Static-Router-Port - HP A5120 EI Series Command Reference Manual

Examples
# Configure GigabitEthernet 1/0/1 in VLAN 2 to be a static member port for (1.1.1.1, 232.1.1.1).
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
[Sysname-vlan2] quit
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1]
vlan 2

igmp-snooping static-router-port

Syntax
igmp-snooping static-router-port vlan vlan-id
undo igmp-snooping static-router-port vlan vlan-id
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN, where vlan-id is in the range of 1 to 4094.
Description
Use the igmp-snooping static-router-port command to configure the current port as a static router port.
Use the undo igmp-snooping static-router-port command to restore the default.
By default, no ports are static router ports.
This command works only on IGMP snooping–enabled VLANs.
This command does not take effect in a sub-VLAN of a multicast VLAN.
In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this command takes effect only if
the interface belongs to the specified VLAN.
In port group view, this command takes effect only on the ports in this port group that belong to the
specified VLAN.
Related commands: subvlan.
Examples
# Configure GigabitEthernet 1/0/1 in VLAN 2 as a static router port.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] igmp-snooping static-router-port vlan 2
igmp-snooping static-group
26
232.1.1.1 source-ip 1.1.1.1