Igmp-Snooping Last-Member-Query-Interval - HP A5120 EI Series Command Reference Manual

Hide thumbs Also See for A5120 EI Series:

Command reference manual (225 pages)

Configuration manual (197 pages)

Installation manual (91 pages)

Table Of Contents

Table of Contents

Use the undo igmp-snooping host-join command to remove the simulated member hosts from the

specified multicast group or source and group.

By default, this function is disabled.

This command works only on IGMP snooping–enabled VLANs, and the version of IGMP on the simulated

host depends on the version of IGMP snooping running in the VLAN.

The source-ip source-address option in the command is meaningful only for IGMPv3 snooping. If IGMPv2

snooping is running, the source-ip source-address option does not take effect although you can include

source-ip source-address in the command.

In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this command takes effect only if

the interface belongs to the specified VLAN.

In port group view, this command takes effect only on those ports in this port group that belong to the

specified VLAN.

Examples

# Configure GigabitEthernet 1/0/1 as a simulated member host in VLAN 2 for multicast source 1.1.1.1

and multicast group 232.1.1.1.

<Sysname> system-view

[Sysname] igmp-snooping

[Sysname-igmp-snooping] quit

[Sysname] vlan 2

[Sysname-vlan2] igmp-snooping enable

[Sysname-vlan2] igmp-snooping version 3

[Sysname-vlan2] quit

[Sysname] interface gigabitethernet 1/0/1

[Sysname-GigabitEthernet1/0/1] igmp-snooping host-join 232.1.1.1 source-ip 1.1.1.1 vlan 2