Mld-Snooping Source-Deny - HP A5120 EI Series Command Reference Manual

vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a VLAN ID
is 1 to 4094.
Description
Use the mld-snooping router-port-deny command to disable a port from becoming a dynamic router
port.
Use the undo mld-snooping router-port-deny command to restore the default.
By default, a port can become a dynamic router port.
This command works only on MLD snooping–enabled VLANs.
If you do not specify any VLAN when using this command in Layer 2 Ethernet interface view or Layer 2
aggregate interface view, the command takes effect in all VLANs that the interface belongs to. If you
specify a VLAN or multiple VLANs, the command takes effect in the specified VLANs that the interface
belongs to.
If you do not specify any VLAN when using this command in port group view, the command takes effect
on all the ports in this group. If you specify a VLAN or multiple VLANs, the command takes effect only on
those ports in this group that belong to the specified VLANs.
Examples
# Disable GigabitEthernet 1/0/1 from becoming a dynamic router port in VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mld-snooping router-port-deny vlan 2

mld-snooping source-deny

Syntax
mld-snooping source-deny
undo mld-snooping source-deny
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Description
Use the mld-snooping source-deny command to enable IPv6 multicast source port filtering.
Use the undo mld-snooping source-deny command to disable IPv6 multicast source port filtering.
By default, IPv6 multicast source port filtering is disabled.
This command works only on MLD snooping–enabled VLANs.
Examples
# Enable source port filtering for IPv6 multicast data on GigabitEthernet 1/0/1.
<Sysname> system-view
61