Igmp-Snooping; Igmp-Snooping Access-Policy - HP A5120 EI Series Command Reference Manual

[Sysname-igmp-snooping] host-aging-time 300

igmp-snooping

Syntax
igmp-snooping
undo igmp-snooping
View
System view
Default level
2: System level
Parameters
None
Description
Use the igmp-snooping command to enable IGMP snooping globally and enter IGMP snooping view.
Use the undo igmp-snooping command to disable IGMP snooping globally.
By default, IGMP snooping is disabled.
Related commands: igmp-snooping enable.
Examples
# Enable IGMP snooping globally and enter IGMP snooping view.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping]

igmp-snooping access-policy

Syntax
igmp-snooping access-policy acl-number
undo igmp-snooping access-policy { acl-number | all }
View
User profile view
Default level
2: System level
Parameters
acl-number: Specifies a basic or advanced ACL number, in the range of 2000 to 3999. The source
address or address range specified in the advanced ACL is used to match the multicast source address or
addresses specified in IGMPv3 reports, rather than the source addresses of the IP packets. The system
assumes that an IGMPv1 or IGMPv2 report or an IGMPv3 IS_EX and TO_EX report that does not carry a
multicast source address carries a multicast source address of 0.0.0.0.
all: Specifies all ACLs.
8