Igmp-Snooping Host-Join - HP A5120 EI Series Command Reference Manual

View
VLAN view
Default level
2: System level
Parameters
interval: Specifies an aging time for dynamic member ports in seconds. The value range is 200 to 1000.
Description
Use the igmp-snooping host-aging-time command to configure the aging time for dynamic member ports
in the current VLAN.
Use the undo igmp-snooping host-aging-time command to restore the default.
By default, the aging time of dynamic member ports is 260 seconds.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: host-aging-time and igmp-snooping enable.
Examples
# Enable IGMP snooping and set the aging time for dynamic member ports to 300 seconds in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping host-aging-time 300

igmp-snooping host-join

Syntax
igmp-snooping host-join group-address [ source-ip source-address ] vlan vlan-id
undo igmp-snooping host-join group-address [ source-ip source-address ] vlan vlan-id
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default level
2: System level
Parameters
group-address: Specifies the address of the multicast group that the simulated host will join, in the range
of 224.0.1.0 to 239.255.255.255.
source-address: Specifies the address of the multicast source that the simulated host will join. The value of
this argument should be a valid unicast address or 0.0.0.0. A source IP address of 0.0.0.0 means no
restriction on the multicast source.
vlan vlan-id: Specifies the VLAN that comprises the ports, where vlan-id is in the range of 1 to 4094.
Description
Use the igmp-snooping host-join command to enable simulated joining on a port. That is, you configure
the current port as a simulated member host for the specified multicast group or source and group.
15