Igmp-Snooping Router-Aging-Time - HP A5120 EI Series Command Reference Manual

current-interface: Specifies the IP address of the current VLAN interface as the source address of IGMP
reports that the IGMP snooping proxy sends. If no IP address has been assigned to the current VLAN
interface, the default IP address 0.0.0.0 is used.
Description
Use the igmp-snooping report source-ip command to configure the source IP address of the IGMP reports
that the IGMP snooping proxy sends.
Use the undo igmp-snooping report source-ip command to restore the default.
By default, the source IP address of the IGMP reports that the IGMP snooping proxy sends is 0.0.0.0.
Before you configure this command in a VLAN, enable IGMP snooping in the VLAN.
The source IP address configured in the igmp-snooping report source-ip command also applies when the
simulated host sends IGMP reports.
Related commands: igmp-snooping enable.
Examples
# Enable IGMP snooping in VLAN 2 and configure the source IP address of IGMP reports that the IGMP
snooping proxy sends in VLAN 2 to 10.1.1.1.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping report source-ip 10.1.1.1

igmp-snooping router-aging-time

Syntax
igmp-snooping router-aging-time interval
undo igmp-snooping router-aging-time
View
VLAN view
Default level
2: System level
Parameters
interval: Dynamic router port aging time, in seconds. The effective range is 1 to 1000.
Description
Use the igmp-snooping router-aging-time command to configure the aging time for dynamic router ports
in the current VLAN.
Use the undo igmp-snooping router-aging-time command to restore the default.
By default, the aging time for dynamic router ports is 105 seconds.
This command takes effect only if IGMP snooping is enabled in the VLAN.
Related commands: igmp-snooping enable and router-aging-time.
22