Xilinx VC707 Getting Started page 8

Chapter 1: Getting Started with the Virtex-7 FPGA VC707 Evaluation Kit
6.
X-Ref Target - Figure 1-4
7.
Install the Terminal Program
Download and install the Tera Term Pro terminal program on the host computer. Tera Term
is available for download at no cost from the
To communicate with the VC707 board, configure the New Connection and Serial Port
settings as shown in
settings shown in
X-Ref Target - Figure 1-5
Preliminary setup is complete and the reference designs can now be run.
8
Send Feedback
Select an unused COM Port Number and then click OK.
selected COM port number.
Figure 1-4: Advanced Settings
Click OK in the properties window
Manager and the Control Panel.
Figure 1-5. These settings must match the host computer COM port
Figure 1-3, page 7
Figure 1-5: TeraTerm Pro Settings
www.xilinx.com
Figure 1-4
Select an unused COM port
(Figure 1-3, page 7), and then close the Device
LogMeTT download page.
and Figure 1-4.
Getting Started with the VC707 Evaluation Kit
UG848 (v1.4.1) October 14, 2015
shows COM1 as the
UG848_c1_04_072612
UG848_c1_05_071112