5.5
Fuji Xerox PS Utility
You can set the printer from your Macintosh using the Fuji Xerox PS Utility. This section
describes how to install, remove, and use the Fuji Xerox PS Utility.
When using the Fuji Xerox PS Utility, set the printer's EtherTalk port status to Enable and make sure that the printer
is set correctly in the Chooser. See the User Guide (Printer/Scanner) for details on setting the port.
5.5.1
Installing the Fuji Xerox PS Utility
The installation procedure is described below.
Procedure
1
Insert the PostScript Driver Library CD-ROM in the CD-ROM drive.
The FXOPS-PS icon appears on the desktop.
2
Double-click the FXOPS-PS.
The FXOPS-PS window opens.
3
Copy the Fuji Xerox PS Utility folder to the Macintosh hard disk.
The Fuji Xerox PS Utility is installed.
See "5.5.3 Using the Fuji Xerox PS Utility" (P. 80) for details about how to use the Fuji Xerox PS
Utility.
Store your CD-ROM in a safe place.
5.5.2
Uninstalling the Fuji Xerox PS Utility
Procedure
1
Move the Fuji Xerox PS Utility folder from the Macintosh hard disk to
the Trash icon.
Uninstallation is complete.
5
79