After Setup; Changing The Connection Port (For Windows 98) - Epson Stylus Scan 2000 Manual

c
3.
When the P
confirm that the head is clean and to reset the cleaning cycle.
If the print quality still has not improved after replacing the ink cartridges, contact your
dealer.

After Setup

Changing the Connection Port (for Windows 98)

If you need to change the port from which the Stylus Scan is connected to your
computer, you must first uninstall the Stylus Scan drivers currently installed in your PC.
Follow the steps below to uninstall the Stylus Scan drivers.
Uninstalling the USB driver
Click Start, point to Settings and Control Panel.
1.
Double-click the Scanners and Cameras icon.
2.
Select EPSON Stylus Scan 2000, then click Remove.
3.
Click OK and close the dialog box.
4.
Double-click the Add/Remove Programs icon.
5.
Select EPSON Printer Software, then click Add/Remove.
6.
7. Select EPSON Stylus Scan 2000, then click OK. Follow the on-screen instructions.
8. After uninstall is complete, select EPSON USB Printer Devices and click Add/
Remove. Then follow the on-screen instructions. The computer restarts automat-
ically.
To connect the Stylus Scan using the parallel port, see "Using the parallel port (for
Windows 95 or 98)" on page 9.
Uninstalling the parallel driver
Click Start, point to Programs, select EPSON Stylus Scan, then click Uninstall
1.
EPSON Stylus Scan SF TWAIN.
2.
Follow the on-screen instructions.
After uninstall is complete, click the Start button, point to Settings, then point
3.
to Control Panel.
Double-click the Add/Remove Programs icon, then select EPSON Printer
4.
Software and click Add/Remove.
5. Select EPSON Stylus Scan 2000, then click OK.
6.
Follow the on-screen instructions.
7.
After completing uninstall, restart your computer.
30
Caution:
Never turn off the EPSON Stylus Scan while the
flashing. Doing so may damage the Stylus Scan.
power light stops flashing, print a few lines from a document to
P power light is
After Setup