Epson Stylus Scan 2000 Quick Start

1
Unpack your

EPSON Stylus Scan

Remove any tape and packing materials.
Make sure you have all the parts. If any parts are missing, contact EPSON
as described in your User's Guide . You'll also need a cable to connect the
printer to your computer.
paper document
support support
software
User's
Guide
3
Plug in
your
EPSON
Stylus
Scan
4
Install the ink
cartridges
2. Open the front cover.
start here
protection
ink cartridges
sheet
printer
1. Lower the tray.
2
Attach the paper
and document
supports
document
support
u u n n f f o o l l d d
Make sure you check the system and location
CAUTION
requirements and follow all the safety
instructions in your User's Guide. Plug the printer into a properly
grounded outlet. If you need help in setting up your printer, see
"Solving Problems" in your User's Guide.
4. Lift up the clamp.
5. Unwrap the ink cartridges. Then
pull off only the yellow part of
the tape seal on top. Don't pull
off the blue portion or remove
the clear seal on the bottom of
the cartridge.
If ink gets on your hands, wash them thoroughly with
WARNING
soap and water. If ink gets in your eyes, flush them
immediately with water. Keep ink cartridges out of the reach of children.
Continue at the top of the next column.
paper support
here
3. Press the power button.
The lights come on and the
print head moves.