A Few Precautions - Epson Stylus Scan 2000 Manual

Unplug the Stylus Scan and refer servicing to qualified service personnel under the
following conditions:
The power cord or plug is damaged; liquid has entered the Stylus Scan; the Stylus
Scan has been dropped or the cabinet damaged; the Stylus Scan does not operate
normally or exhibits a distinct change in performance.
To provide adequate short-circuit protection and over-current protection for this
Stylus Scan, the building installation must be protected by a 16 Amp circuit breaker
This device contains batteries and should not therefore be disposed of with
normal domestic waste. Please dispose of the device in accordance with
local statutory regulation.

A Few Precautions

When using the Stylus Scan
Do not put your hand inside the Stylus Scan or touch the ink cartridges during
operation.
Do not move the print head by hand. Doing so may damage the EPSON Stylus Scan.
Always use the
button, the P
Scan or turn off the power to the outlet until the
Before transporting the Stylus Scan, make sure the print head is in the home (far
right) position and the ink cartridges are in place.
When handling the ink cartridges
Keep ink cartridges out of the reach of children. Do not allow children to drink the
ink or otherwise handle the cartridges.
If ink gets on your skin, wash it off with soap and water. If ink gets into your eyes,
flush eyes immediately with water.
Do not shake the ink cartridges. Cartridges may leak if shaken.
Install the ink cartridge immediately after you remove it from its package. Leaving
the cartridge unpacked for a long time before use may result in reduced print quality.
Once you install an ink cartridge, do not open the clamp or remove the cartridge
except to replace it with a new one. Otherwise the cartridge may become unusable.
Do not use an ink cartridge beyond the date printed on the cartridge carton. For best
results, use up the ink cartridges within six months of installing them.
Do not dismantle the ink cartridges or try to refill them. Doing so may damage the
print head.
Important Safety Instructions
P power button to turn off the Stylus Scan. After pressing this
power light flashes briefly then goes off. Do not unplug the Stylus
P power light stops flashing.
5