Printing The Nozzle Check Pattern - Epson Stylus Scan 2000 Manual

1.
Lower the output tray and slide out the extension. Next, slide the paper edge guide
to adjust the width of the loading area so that it is slightly wider than the width of
your paper.
paper edge guide
output tray
2.
Fan a stack of paper; then tap it on a flat surface to even the edges.
3.
Load the stack of paper with the printable side up and the right edge of the paper
resting against the right side of the paper feeder. Then slide the edge guide against
the edge of the paper.
Note:
Always load paper into the paper feeder short edge first.
Make sure the paper stack fits under the arrow mark inside the edge guide.

Printing the Nozzle Check Pattern

Follow the on-screen instructions to check the print-head nozzles. If you do not see any
on-screen instructions, follow these instructions.
28
printable side up
Checking the Stylus Scan