Change Your Passcode; Set Answer Mode; Automatic Hold - Samsung iDCS500 User Manual

Samsung iDCS500

CHANGE YOUR PASSCODE

By default, your extension passcode is 1234. You can change this passcode
to any 4-digit number. You may be required to do this in order to use some
special features.
1. While on-hook, dial TRSF 101.
2. Dial your existing (old) passcode.
3. Dial a new passcode (must be four digits, e.g. 3456). You can use num-
bers 0–9.
4. Redial the new passcode to verify. If successful, you will hear two beeps.
(Four beeps indicate an invalid code and you should enter the code
again.)
5. Press the TRSF key to store the new passcode.

SET ANSWER MODE

You can receive internal calls in one of three modes: Ringing, Auto Answer or
Voice Announce (see
for details).
1. While on-hook, dial TRSF 103.
2. Dial 0 for Ringing, 1 for Auto Answer or 2 for Voice Announce. (Or use
the VOLUME keys to select the option in the display.)
3. Press the TRSF key to store your selection.

AUTOMATIC HOLD

While on an outside call, pressing a line key, route key or a flashing CALL
key will automatically put your call on hold and connect you to the next call.
This feature can be turned on or off at your keyset.
1. While on-hook, dial TRSF 110.
2. Dial 001 to turn Automatic Hold on or 000 to turn it off. (Or use the soft
keys and VOLUME keys to select the option in the display.)
3. Press the TRSF key to store your selection.
Answering Internal Calls
– 51 –
DCS (Euro) Keyset User Guide
in the section "Internal Calls"