Starcom Systems Helios User's Manual Manual page 150

Helios Users Guide
Testing
After the unit was properly installed, you should test the connection. Open the
Installer Application, go to Technical > Helios Canbus, select OBD-II as the
vehicle type, and click Connect. If everything is correct, you will see the
information that the unit can retrieve from the vehicle, as shown in the
following image.
NOTE: The mileage displayed is the mileage registered since the codes were last
cleared. It will be used by the unit as a relative mileage to count the mileage
the vehicle has covered and will not be used as an absolute value, so don't
worry if it does not match the actual mileage in the vehicle.
Configuration
After validating that the data is correct, open Helios Parameters > Hardware.
In the Canbus Vehicle section, select OBD-II in the Type list, ALL in the Model
list, and 0 in the Year list. Click Send and make sure you receive a response
from the unit.
www.starcomgpsglobal.com 150