Table of Contents
Advertisement
WARNING
Battery terminals or metal tools could short
against metal tractor components causing
sparks. Sparks can cause the battery gasses to
explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the tractor.
• Do not allow metal tools to short between
the battery terminals and metal parts of
the tractor.
7. Install the battery into the machine and secure it.
Important: The battery must not be able to move
or wiggle when pushed.
8. First, install the positive cable (red) to the positive (+)
terminal and then the negative cable (black) to the
negative (-) terminal of the battery. Slide the rubber
boot over the positive terminal to prevent a possible
short from occurring.
WARNING
Incorrect battery cable routing could damage
the machine and cables causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative
(black) cable.
WARNING
Connecting cables to the wrong post could
damage the electrical system and result in
personal injury.
Note: Ensure that the battery cables are routed away
from any sharp edges or moving parts.
3
Installing the Mower
Deck/Polar Trac
Parts needed for this procedure:
1
Mower Deck or Polar Trac Kit (sold separately)
Installing a Mower Deck Kit
1. Remove the traction unit from the shipping pallet.
2. Place a jack stand under each wheel motor and a floor
jack under the rear bumper (Figure 5), or suspend from
a over head hoist.
1. Rear bumper
3. Install the summer drive tires (Figure 6)
1. Summer drive tire
4. Roll the summer deck and frame into position and
install the five 3/4 inch bolts, washers and nuts that
connect the deck frame to the rear frame (Figure 7).
11
Figure 5
2. Floor jack
Figure 6
Advertisement
Table of Contents
