Toro 30381N Operator's Manual page 13

Figure 11
1. Drive shaft
2. Gear box
8. Route and connect the hydraulic pressure and tank
hoses to the valve (Figure 12).
Figure 12
1. Control valve
2. Tank hose
9. Install the rear of the deck lift cylinder onto the pivot
pin and secure with the retaining ring (Figure 13).
10. Secure the front of the lift cylinder to the mower frame
with the cylinder pin and screw (Figure 13).
3. Bolt
4. Roll pin
3. Pressure hose
1. Deck lift cylinder
2. Retaining ring
11. Position the ROPS assembly onto the ROPS posts.
Install the bolt, nut, hair pin cotter and pin securing
each ROPS assembly to the ROPS posts (Figure 14).
Note: If installing an allied suppliers mower deck,
ROPS Kit, part no. 117– 9179 must be installed.
1
2
5
1. ROPS
2. Pin
3. Cotter pin
12. Start the machine, raise and lower the deck. Check for
leaks and make sure the hoses do not rub against the
frame.
Installing the Polar Trac Kit
1. Remove the traction unit from the shipping pallet.
2. Place a jack stand under each wheel motor and a floor
jack under the rear bumper (Figure 15) or suspend
from a over head hoist.
13
Figure 13
3. Screw
4. Cylinder pin & screw
4
3
G004634
Figure 14
4. Bolt & nut
5. ROPS post