Toro 30381N Operator's Manual page 29

Figure 55
1. Press to lower the
attachment/lift arm
2. Press to swing the
attachment to the left
Important: Do not continue to hold a pedal after the
attachment has finished moving. Doing so will damage
the hydraulic system.
Connecting/Disconnecting an
Attachment
Read the Operator's Manual supplied with the attachment
before operating.
1. Lower the front lift arm.
2. Drive the machine into position behind the attachment
adapter.
3. Raise the machine adapter on the lift arm into the
attachment adapter.
4. Secure the adapters together with the attachment pin
and hairpin cotter as shown in Figure 56.
Figure 56
1. Attachment pin
3. Press to raise the
attachment/lift arm
4. Press to swing the
attachment to the right
2. Cotter pin
5. If the attachment is powered by hydraulics, connect
the hydraulic coupler on the attachment to those on
the front lift arm.
Important: Ensure that the couplers are clean
before connecting them to prevent hydraulic
system contamination.
6. If the attachment is powered by the PTO, extend the
attachment PTO shaft and insert it onto the machine
PTO shaft (Figure 57).
1. PTO shaft
Note: To remove an attachment, perform the above steps
in reverse.
Engaging the Power Take Off (PTO)
The power take off (PTO) switch starts and stops powered
attachments.
1. If the engine is cold, allow the engine to warm up 5 to
10 minutes before engaging the PTO.
2. While seated in the seat, release the pressure on the
traction control levers and place them in neutral.
3. Pull up on the PTO switch to engage it (Figure 58).
1. PTO switch
Disengaging the PTO
To disengage, push the PTO switch to the off position.
29
Figure 57
Figure 58