Toro 30381N Operator's Manual page 17

Figure 27
1. Jacking bolts
14. Connect the hydraulic pressure hose to the valve hard
line and the tank hose to the valve (Figure 28). Retain
the hose plugs for the summer change over.
Note: Make sure the hoses are note kinked or are
rubbing against any moving parts.
Note: Adjust the angle of the fittings to accommodate
the routing of the hoses.
1
2
Figure 28
1. Pressure hose
15. Raise the rear of the machine until 2 jack stands can be
positioned under the rear tube at a height that supports
the rear tires 2.5 to 7.5 cm (1 to 3 inches) off of the
ground.
16. Lower the floor jack so the rear frame rests on the jack
stands. Position the floor jack under the center of the
front lift arm pivot tube.
17. Remove the flat washer (1/2 inch) and nut (1/2 inch)
installed on the stud on the bogie pivot (Figure 29).
2. Cab jack tube
G009488
2. Tank hose
1. Washer & nut on the bogie pivot stud
18. Raise the floor jack until the front tires are off of the
ground high enough to install the track beneath them
and support the frame with jack stands.
19. Remove the front and center tires from the winter
assembly (Figure 30).
1. Front tire
20. Carefully lift the tracks over the rear wheel and front
hubs. The direction of the track rotation is printed on
the track. The V design in the rubber track must point
forward.
CAUTION
The track guides have many pinch points.
Carefully grasp the rubber track on the outer
edges outboard of the steel guides when
moving the track.
21. Adjust the floor jack to a suitable height to install the
front tire. With a helper, lift the front of the track
enough to carefully install the front tires (Figure 31).
17
Figure 29
Figure 30