Table of Contents
Advertisement
3. After the radiator is thoroughly cleaned, clean out
debris that may have collected in the channel at the
radiator base.
4. Close the hood.
Brake Maintenance
Adjusting the Parking Brake
Interlock Switch
1. Stop the machine, move the control levers fully into
the neutral-locked position, set the parking brake, and
remove the ignition key.
2. Unlatch the seat and pivot it forward.
Note: If additional access is required under the seat,
the side panels may be removed.
3. Loosen the two jam nuts securing the parking brake
interlock switch to the mounting bracket.
1. Brake shaft sensor
2. Jam nuts
4. Move the switch up or down on the bracket until the
distance between the brake shaft sensor and the switch
surface is 3.9 mm (5/32 inch) (Figure 67).
Note: Make sure the brake shaft sensor does not
contact the switch plunger.
5. Secure the switch jam nuts.
6. Test the adjustment as follows:
A. Ensure that the parking brake is engaged and you
are not sitting on the seat, then start the engine.
B. Move the control levers out of the neutral locked
position.
The engine should stop. If not, recheck the
adjustment you made to the switch.
7. Lower the seat.
39
Figure 67
3. Parking brake interlock
switch
4. 5/32 inch (3.9 mm)
Advertisement
Table of Contents
