Setup; Installing The Upper Handle And Controls - Toro 62925 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Upper handle assembly
Bag support
Bolt (5/16 x 1-1/2 inches)
Locknut (5/16 inch)
Bolt (10-32)
1
Locknut (10-32)
Rope guide
Bolt (1/4 x 3/4 inch)
Locknut (1/4 inch)
Height control rod
Hair pin cotter
Bolt (1/4 x 1/2 inch)
2
Lock washer (1/4 inch)
Debris bag
Blower tube
3
Blower intake screen
Locknut
Step
1
Installing the Upper Handle
and Controls
Parts needed for this step:
1 Upper handle assembly
1 Bag support
4 Bolt (5/16 x 1-1/2 inches)
4 Locknut (5/16 inch)
1 Bolt (10-32)
1 Locknut (10-32)
1 Rope guide
1 Bolt (1/4 x 3/4 inch)
1 Locknut (1/4 inch)
1 Height control rod
2 Hair pin cotter
Procedure
1. Attach the upper handle to the lower handle
with 4 bolts (5/16 x 1-1/2 inches) and locknuts
(5/16 inch) (Figure 3).
Description
1. Lower handle
2. Upper handle
2. Secure the bag support to the inside of the
3. Secure starter rope guide to the lower handle
7
Qty.
1
1
4
4
1
Install the upper handle and
1
controls.
1
1
1
1
2
1
1 Install the discharge chute.
1
1
1
Install the snout.
3
Figure 3
3. Bag support
4. Rope guide
lower handle while mounting the handle
(Figure 3).
with a bolt (1/4 x 1-3/4 inches) and locknut
(1/4 inch) (Figure 4).
Use