Toro 62925 Operator's Manual page 17

Figure 23
Housing in Blower Position
1. Lower blower housing
mounting bracket
2. Front edge of engine base
3. Bolt
13. Secure the bracket to the engine bracket with
the bolt removed previously (Figure 23).
14. Install the blower intake screen, securing it
with 1 of the washers and locknuts removed
in step 2 (Figure 21).
Note: Do not use the retainer flange with the
blower intake screen.
The air stream comes out of the blower
in excess of 100 mph (160 km/h)and can
cause bodily injury or property damage.
Ensure that the air stream is not aimed
directly at anybody or anything.
4. Engine bracket
5. Locknuts and housing
mounting studs
17