Installing The Discharge Chute; And Bag - Toro 62925 Operator's Manual

Figure 4
1. Bolt (1/4 x 1-3/4 inches)
2. Locknut (1/4 inch)
4. Pull the starter rope through the guide
(Figure 4).
5. Hook the lower end (ball end) of the traction
control wire in the keyhole slot in the arm on
the traction drive guard (Figure 5).
Figure 5
1. Traction control wire
2. Traction drive guard
6. Secure the ball in the keyhole slot with a bolt
(10-32) and nut (10-32) (Figure 5).
Note: Make sure ball end of cable is not
between screw head and drive guard.
7. Secure the lower end of the height control rod
to the bracket on the front wheel support with
a hairpin cotter (Figure 6).
3. Pull rope through rope
guide
3. Bolt and nut (10–32)
Figure 6
1. Height control rod
2. Front wheel support
bracket
8. Secure the upper end of the height control rod
to the height adjustment handle with a hairpin
cotter (Figure 7).
Figure 7
1. Height control rod
2. Height adjustment handle
Step
2
Installing the Discharge
Chute and Bag
Parts needed for this step:
1 Bolt (1/4 x 1/2 inch)
1 Lock washer (1/4 inch)
1 Debris bag
Procedure
1. Install the discharge chute and secure it with
a bolt (1/4 x 1/2 inch) and lock washer (1/4
inch) (Figure 8).
8
3. Hairpin cotter
3. Hairpin cotter