Installing The Snout - Toro 62925 Operator's Manual

Figure 8
1. Chute
2. Position the bag onto the handle, hooking the
grommets over the pins and the bag strap over
the handle (Figure 9).
Figure 9
1. Grommets
3. Slip the elasticized neck of the bag over the
flanges on the chute (Figure 9).
2. Bolt (1/4 inch) and lock
washer
2. Elasticized neck
Step
3

Installing the Snout

Parts needed for this step:
1 Blower tube
1
Blower intake screen
3 Locknut
Procedure
1. Mount the lower edge of the snout flange into
the mounting bracket (Figure 10).
Figure 10
1. Vacuum snout
2. Lower edge of ange
2. Position the retainer flange over the 3 bolt ends
protruding through the snout (Figure 10).
3. Secure the snout and flange to the blower with
3 washers and locknuts (Figure 10).
9
3. Retainer ange
4. Locknut