Toro 62925 Operator's Manual page 16

Figure 20
1. Vacuum snout
2. Lower edge of ange
3. Remove the bag neck from blower discharge
chute (Figure 21). (You may remove the entire
bag if desired.)
Figure 21
1. Bag neck
2. Blower discharge chute
4. Remove the retaining bolt and lock washer
securing the blower discharge chute and
remove the chute (Figure 21).
5. Install the blower tube, securing it with the
fasteners removed in step 4 (Figure 21).
6. Remove bolt securing blower housing to
engine bracket (Figure 22).
3. Retainer ange
4. Locknut
3. Blower tube
4. Blower intake screen
Figure 22
Housing in Vacuum Position
1. Bolt
2. Housing
3. Engine bracket
7. Remove the 2 locknuts securing housing
to engine bracket and remove the bracket
(Figure 22).
8. Install the 2 locknuts on the housing mounting
studs for safe keeping.
9. Remove the 2 locknuts securing housing to
stabilizer bracket (Figure 22).
10. Lift blower housing slightly and rotate it 120°
clockwise (as you face the blower) (Figure 21).
11. Reseat the housing, nesting the lower blower
housing mounting bracket onto the front edge
of the engine base (Figure 23).
12. Install engine bracket on the housing mounting
studs with 2 locknuts (Figure 23).
16
4. Locknuts and housing
mounting studs
5. Locknuts
6. Stabilizer bracket