Setup - Toro Sand Pro Cyclone 1000 Operator's Manual

Setup

Note: Use this chart as a checklist to ensure that all parts have been received. Without these parts, total setup cannot be
completed.
Description
Blower Assembly
*Relay
*Capscrew #10–24 x .38" lg.
*Nut #10–24
*Wire Harness
*Wire Tie
*Spline Shaft
*Key
*Square Head Setscrew
*Power Take–Off Cover
*Capscrew 3/8–16 x .50" lg.
(Sand Pro 2020/3020)
(Sand Pro 5000/5020 only)
*Flat Washer .40 I.D. x .81 O.D.
(Sand Pro 2020/3020)
(Sand Pro 5000/5020 only)
*Receiver Bracket
*Capscrew 3/8–16 x 1.25" lg.
(Sand Pro 2020/3020 only)
*Capscrew 3/8–16 x 1.50" lg.
(Sand Pro 5000/5020 only)
*Flat Washer .40 I.D. x .81 O.D.
*Locknut 3/8–16
*Capscrew 1/2–13 x .875" lg.
*Flat Washer .56 I.D. x 1.063 O.D.
*Spacer .25" Thk.
(Sand Pro 2020/3020 w/ fenders only)
*Spacer .625" lg.
(Sand Pro 5000/5020 only)
*Spacer .375" lg.
(Sand Pro 5000/5020 w/ matt rack only)
Bumper Assembly
Capscrew 3/8–16 x 2.00"
Flat Washer .40 I.D. x .81 O.D.
Locknut 3/8–16
Qty. Use
1 Mounting
1 Mount to Sand Pro frame
1
Connect neutral switch wire to harness
1
1
Connect to relay, solenoid & blower
4
1
1
2
1
Mount spline shaft to output shaft
2
4
2
4
2
2
2
2
2
2 Mount to Sand Pro frame
2
2
2
2
1
4
Mount to blower frame
4
4
8