Driving The Machine Forward; Using The Debris Bag; Converting From Vacuum To; Blower - Toro 62925 Operator's Manual

Figure 17
1. Height adjustment control
4. Return the castor wheels to the ground
Driving the Machine
Forward
Hold the traction control lever (Figure 18) against
the handle to move forward. Release the traction
control lever to stop forward motion.
Figure 18
1. Traction control lever (disengaged)

Using the Debris Bag

Emptying the Debris Bag
When the debris bag is full, empty it as follows:
Note: You do not need to remove the bag to
empty it.
1. Drive to the location where you want to dump
the debris.
2. Stop the engine.
3. Unzip the side of the bag and dump the
contents (Figure 19).
Figure 19
1. Zipper for emptying
4. Close the zipper before starting the engine.
A worn debris bag could allow small
stones and other similar debris to be
thrown in the operator's or bystander's
direction and result in serious personal
injury or death to the operator or
bystanders.
Check the debris bag frequently. If it is
damaged, install a new Toro replacement
bag.
Using the Bag Vent
The bag has a zippered vent (Figure 19). When
vacuuming an area which is basically free of dust,
open the side vent should be open to allow free
movement of air. When vacuuming a dusty area,
close the vent.
Important: Keep the inside of the bag clean
to allow the air to circulate properly.

Converting from Vacuum to

Blower

1. Stop the engine.
2. Remove the locknuts, washers, and retainer
flange securing the snout and remove the snout
(Figure 20).
15
2. Bag vent