Setup; Installing The Caster Wheels; Connecting The Lower Link Arms - Toro Debris Blower 600 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
Media and Additional Parts
Description
Operator's Manual
Parts Catalog
CE Decal 105-0698
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Installing the Caster Wheels

No Parts Required
Procedure
Install a caster wheel assembly between each caster fork with
4 washers, an axle, and 2 cotter pins
Description
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
(Figure 2).
Qty.
–
–
–
–
–
–
–
–
–
Qty.
1 Review the manual before operating the machine.
1 Use the parts catalog to reference product part numbers.
1 Apply over decal 105-0707 for CE compliance.
1. Wheel assembly
2. Caster fork
6
Use
Install the caster wheels.
Connect the lower link arms.
Connect the upper link.
Adjust the PTO shaft length.
Connect the PTO shaft.
Adjust the sway links.
Adjust the 3-point-lift stop.
Remove the blower from the tractor.
Grease the blower.
Use
Figure 2
3. Axle