Table of Contents
Advertisement
Figure 24
1. Seat suspension knob
Changing the Back Position
The back of the seat can be adjusted to provide a
comfortable ride. Position the back of the seat where it
is most comfortable.
To adjust it, turn the knob, under the right-side arm
rest, in either direction to provide the best comfort
(Figure 23).
Changing the Lumbar Support
The back of the seat can be adjusted to provide a
customized lumbar support for your lower back.
To adjust it, turn the knob under the left-side arm
rest, in either direction to provide the best comfort
(Figure 23).
Unlatching the Seat
To access the hydraulic and other systems under the
seat, you need to unlatch the seat and swing it forward.
1. Use the seat position adjustment lever to slide the
seat all the way forward.
2. Push one of the seat latches, located behind and to
the sides of the seat, rearward to unlatch the seat
and pull forward on the top of the seat (Figure 25).
2. Operator weight setting
1. Seat latch
Moving a Non-functioning
Machine
If the machine breaks down, runs out of fuel, etc. you
may need to pull it with a winch to load it onto a trailer..
To do so, you first need to open the hydraulic by-pass
valves.
Important: Never tow the machine because
hydraulic damage may occur.
Moving the Machine
1. Disengage the power take off (PTO) and turn
the ignition key to off. Move the levers to the
neutral locked position and apply the parking brake.
Remove the key.
2. Lift the seat.
3. Rotate both by-pass valves counterclockwise 1 turn
(Figure 26).
This allows hydraulic fluid to by-pass the pump
enabling the tracks to turn .
Important: Do not rotate the by-pass valves
more than 2.5 turns. This prevents valves from
coming out of the body and causing fluid to
run out.
23
Figure 25
Advertisement
Table of Contents
