Table of Contents
Advertisement
1. Side panel cover
The cab fuses are located in front of the cab control
panel (Figure 40). Access them by removing the finger
bolts securing the fuse access cover.
1. Thumb screws
2. Fuse access cover
If the machine stops or has other electrical system issues,
check the fuses. Grasp each fuse in turn and remove
them one at a time, checking to see if any are blown. If
you need to replace a fuse, always use the same type
and amperage rated fuse as the one you are replacing,
Figure 39
2. Latches
Figure 40
3. Cab fuses
otherwise you could damage the electrical system.
Refer to the decal next to the machine fuses (Figure 41)
for a diagram of each fuse and its amperage (the cab
fuses are all 20A fuses and are used to protect the heater,
windshield wipers, lights, fan, and other cab functions).
Note: If a fuse blows frequently, you probably have a
short in the electrical system and should have it serviced
by a qualified service technician.
35
Figure 41
Advertisement
Table of Contents
