Table of Contents
Advertisement
Figure 58
1. Hydraulic reservoir drain
plug
2. Filter
4. Clean the area around the hydraulic oil filter and
remove it (Figure 58).
5. Immediately install a new hydraulic oil filter.
6. Install the hydraulic reservoir and transmission case
drain plugs.
7. Fill the reservoir to the proper level; refer to
Checking the Hydraulic Fluid.
8. Start the engine and check for oil leaks. Allow the
engine to run for about five minutes, then shut it off.
9. After two minutes, check the level of the hydraulic
fluid; refer to Checking the Hydraulic Fluid.
3. Transmission case drain
plug
Cab Maintenance
Refer to the ROPS Hard Cab Operator's Manual for
additional cab maintenance procedures.
44
Advertisement
Table of Contents
