Table of Contents
Advertisement
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Operating Attachments
Changing the Attachment Orientation
Use the attachment control pedals (Figure 17) to
control the physical orientation of the attachment. Use
the left pedal to raise and lower the attachment. Use the
right pedal to swing the attachment to the right or left.
Note: The right pedal is not used on all attachments.
Also, on snowthrowers, only the chute swings right
and left.
Figure 17
1. Press to lower the
attachment/lift arm
2. Press to swing the
attachment to the left
Important: Do not continue to hold a pedal after
the attachment has finished moving. Doing so will
damage the hydraulic system.
Connecting/Disconnecting an
Attachment
Read the Operator's Manual supplied with the attachment
before operating.
1. Lower the front lift arm.
2. Drive the machine into position behind the
attachment adapter.
3. Press to raise the
attachment/lift arm
4. Press to swing the
attachment to the right
3. Raise the machine adapter on the lift arm into the
attachment adapter.
4. Secure the adapters together with the attachment
pin and hairpin cotter as shown in Figure 18.
1. Attachment pin
5. If the attachment is powered by hydraulics, connect
the hydraulic coupler on the attachment to those on
the front lift arm.
Important: Ensure that the couplers are clean
before connecting them to prevent hydraulic
system contamination.
6. If the attachment is powered by the PTO, extend
the attachment PTO shaft and insert it onto the
machine PTO shaft (Figure 19).
1. PTO shaft
Note: To remove an attachment, perform the above
steps in reverse.
20
Figure 18
2. Cotter pin
Figure 19
Advertisement
Table of Contents
