Table of Contents
Advertisement
The machine can turn very rapidly. You may
lose control of it and cause personal injury or
damage to machine.
• Use caution when making turns.
• Slow the machine down before making
sharp turns.
1. Release the parking brake.
Note: The engine will kill if the traction control
levers are moved with the parking brake engaged.
2. Move the levers to the center, un-locked position.
3. Drive the machine as follows:
• To go straight forward, slowly push the motion
control levers forward (Figure 16).
• To go straight rearward, slowly pull the motion
control levers rearward (Figure 16).
• To turn, slow the machine by pulling back on
both levers and then push forward on the lever
on the opposite side from which you want to
turn (Figure 16).
• To stop, pull the motion control levers to the
neutral position.
Note: The farther you move the traction control
levers in either direction, the faster the machine will
move in that direction.
1. Motion control
lever-neutral locked
position
2. Center un-lock position
Stopping the Machine/Engine
1. Move the traction control levers to neutral and to
the locked position.
2. Disengage the PTO, set the parking brake, and
move the throttle lever to the Slow position.
3. Let the engine idle for 60 seconds.
4. Turn the ignition key to the Off position (Figure 15).
Wait for all moving parts to stop before leaving the
operating position.
5. Remove the key before transporting or storing
machine.
Important: Make sure to remove the key as the
fuel pump or accessories may run and cause
the battery to lose charge.
19
Figure 16
3. Forward
4. Backward
Advertisement
Table of Contents
