Hardware Setup - Onkyo HT HT-S7300 Instruction Manual

Miscellaneous
Main menu
Volume Setup
■
Maximum Volume
Off, 30 to 79
With this setting, you can limit the maximum vol-
ume.
To disable this setting, select "Off".
■
Power On Volume
Last, Min, 1 to 79 or Max
With this preference, you can specify the volume set-
ting to be used each time the AV receiver is turned
on.
To use the same volume level that was used when the
AV receiver was turned off, select "Last".
The "Power On Volume" cannot be set higher than
the "Maximum Volume" setting.
■
Headphone Level
–12dB to 0dB to +12dB
With this preference, you can specify the headphone
volume relative to the main volume. This is useful if
there's a volume difference between your speakers
and your headphones.
OSD Setup
■
On Screen Display
This preference determines whether operation details
are displayed on-screen when an AV receiver function is
adjusted.
On:
Displayed.
Off:
Not displayed.
Even when "On" is selected, operation details may not be
output if the input source is connected to an HDMI IN.
■
Language
English, Deutsch, Français, Español, Italiano,
Nederlands, Svenska, 中文
This setting determines the language used for the on-
screen setup menus.
En
48
Miscellaneous

Hardware Setup

Main menu Hardware Setup
Remote ID
■
Remote ID
1, 2, or 3
When several Onkyo components are used in the same
room, their remote ID codes may overlap. To differenti-
ate the AV receiver from the other components, you can
change its remote ID from "1", to "2" or "3".
Note
• If you do change the AV receiver's remote ID, be sure to change
the remote controller to the same ID (see below), otherwise, you
won't be able to control it with the remote controller.
Changing the Remote Controller's ID
1
While holding down RECEIVER, press and hold
down SETUP until the remote indicator lights
(about 3 seconds) (➔
2
Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.
Tuner
For FM/AM tuning to work properly, you must specify the
FM/AM frequency step used in your area. Note that when
this setting is changed, all radio presets will be deleted.
■
FM/AM Frequency Step
200k/10kHz:
Select if 200 k/10 kHz steps are used in your area.
50k/9kHz:
Select if 50 k/9 kHz steps are used in your area.
38).