Basic Operations; Displaying Source Information - Onkyo HT HT-S7300 Instruction Manual

Basic Operations

The on-screen menus appear only on a TV that is con-
nected to the HDMI OUT. If your TV is connected to
the MONITOR OUT V or the COMPONENT VIDEO
OUT, use the AV receiver's display when changing
settings.
This manual describes the procedure using the
remote controller unless otherwise specified.
Selecting the Language Used for the
Onscreen Setup Menus
You can determine the language used for the onscreen
setup menus. See "Language" in the "OSD Setup"
48).
(➔
Playing the Connected Component
■
Operating on the AV receiver
1
Use the input selector buttons to select the input
source.
2
Start playback on the source component.
See also:
• "Controlling Other Components"
• "Controlling iPod" (➔
• "Listening to the Radio"
3
To adjust the volume, use the MASTER VOLUME
control.
4
Select a listening mode and enjoy!
See also:
• "Using the Listening Modes"
• "Audyssey" (➔ 44)
■
Operating with the remote controller
1
Press RECEIVER followed by INPUT SELEC-
TOR.
2
Start playback on the source component.
See also:
• "Controlling Other Components"
• "Controlling iPod" (➔
• "Listening to the Radio"
3
To adjust the volume, use VOL q/w.
4
Select a listening mode and enjoy!
See also:
• "Using the Listening Modes"
44)
• "Audyssey" (➔
60)
(➔
56)
(➔ 30)
33)
(➔
60)
(➔
56)
30)
(➔
(➔ 33)
■
Adjusting the subwoofer volume level
Use the subwoofer's OUTPUT LEVEL control to
adjust the volume of the subwoofer.
Because our ears are less sensitive to very low bass
sounds, there's a temptation to set the level of the
subwoofer too high. As a rule of thumb, set the sub-
woofer level to what you think is the optimal level,
and then back it off slightly.
Note
• When the subwoofer volume level is set to a positive (+) value,
the maximum master volume level is reduced proportionally.

Displaying Source Information

You can display various information about the current
input source as follows. (Components connected to the
UNIVERSAL PORT jack are excluded.)
Press RECEIVER followed by DISPLAY repeat-
edly to cycle through the available information.
Tip
• Alternatively, you can use the AV receiver's DISPLAY.
The following information can typically be displayed.
Input source &
*1
volume
Signal format *2
or sampling
frequency
Input & output
resolution
Input source &
listening mode *3
*1 When AM or FM radio is used, the band, preset number, and
frequency are displayed.
*2 If the input signal is analog, no format information is dis-
played. If the input signal is PCM, the sampling frequency is
displayed. If the input signal is digital but not PCM, the signal
format is displayed.
Information is displayed for about three seconds, then the pre-
viously displayed information reappears.
*3 The input source is displayed with the default name even
when you have entered a custom name in "Name Edit"
(➔ 45).
En
25