Setting The Powered Zone 2; Using Zone 2 - Onkyo HT HT-S7300 Instruction Manual

Setting the Powered Zone 2

If you've connected your Zone 2 speakers to the AV
receiver, as explained in "Connecting Your Zone 2 Speak-
ers Directly to the AV receiver"
"Front High/Zone2" setting to "Zone2".
Main menu
1
In the "Speaker Setup" menu, select "Speaker
Settings", and then press ENTER.
2
Use q/w to select "Front High/Zone2" and e/r to
select "Zone2".
Zone2:
Zone 2 speakers can be used (Powered Zone 2
enabled).
Note
• When "Zone2" is selected and Zone 2 turned on, the Zone 2
speakers connected to the FRONT HIGH OR ZONE 2
SPEAKERS terminals output sound, but the surround back or
front high speakers connected to the SURR BACK OR
FRONT HIGH SPEAKERS terminals do not. When "Zone2"
is selected and Zone 2 turned off, the surround back or front high
speakers output sound as normal.
• When the "Front High/Zone2" setting is set to "Zone2" and the
input selector of Zone 2 is selected, power consumption on
standby mode slightly increases.
En
54
(➔ 53), you must set the
Speaker Setup

Using Zone 2

This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust the
volume for Zone 2.
Controlling Zone 2 from the AV receiver
OFF
ZONE 2
ZONE 2 indicator
1
To turn on Zone 2 and select an input source, press
ZONE 2 followed by an input selector button
within 8 seconds.
Zone 2 turns on, the ZONE 2 indicator lights.
To select AM or FM, press the TUNER input selec-
tor button repeatedly.
To select the same source as that of the main room,
press ZONE 2 repeatedly until "Z2 Selector:
Source" appears on the display.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2. The same FM/AM radio sta-
tion will be heard in each room.
2
To turn off Zone 2, press OFF.
Note
• While Powered Zone 2 is being used, listening modes that
require surround back and front high speakers (6.1/7.1), such as
Dolby Digital EX, DTS-ES, and Dolby Pro Logic IIz Height are
unavailable.
• When the "Front High/Zone2" setting is set to "Zone2" and the
input selector of Zone 2 is selected, power consumption on
standby mode slightly increases.
– /+
Input selector buttons