Hardware Setup - Onkyo HT S3200 Instruction Manual

Advanced Setup—Continued
T-D (Theater-Dimensional) Setting
LstnAngl (Listening Angle)
Wide: Select if the listening angle is 40 degrees (default).
Narrow: Select if the listening angle is 20 degrees.
With this setting, you can optimize the Theater- Dimensional listening
mode by specifying the angle of the front left and right speakers relative
to the listening position. Ideally, the front left and right speakers should
be equidistant from the listening position and at an angle close to one of
the two available settings.

Hardware Setup

This section explains items on the Hardware menu.
8. Hardware
Remote ID
When several Onkyo components are used in the same room, their remote ID codes may overlap. To differentiate
the AV receiver from the other components, you can change its remote ID from 1, the default, to 2 or 3.
Remote ID 1, 2, 3
Note:
If you do change the AV receiver's remote ID, be sure to change the remote controller to the same ID (see below),
otherwise, you won't be able to control it with the remote controller.
Changing the Remote Controller's ID
1
While holding down the [RECEIVER] button, press and hold down the
[SETUP] button until the Remote indicator lights up (about 3 seconds).
2
Use the number buttons to enter ID 1, 2, or 3.
The Remote indicator flashes twice.
Tuner
FM/AM (North American/Taiwan models)
See "AM/FM Frequency Step Setup" on page 42.
AM Freq (Asian model)
See "AM/FM Frequency Step Setup" on page 42.
Front left Front right
speaker speaker
20°/40°
57